The Hitachi selecset is made by Comdial and looks (inside and out) exactly like an Impact phone. Does anyone know if Hitachi offered a 'flat.

• HITACHI INVERTER L700 SERIES Quick Reference Guide Read through this Instruction Manual, and keep it handy for future reference. • Thank you for purchasing the Hitachi L700 Series Inverter. This Quick Reference guide describes how to handle and maintain the Hitachi L700 Series Inverter. Read this Instruction Manual carefully before using the inverter, and then keep it handy for those who operate, maintain, and inspect the inverter. • Safety Instructions Safety Instructions Be sure to read this Instruction Manual and appended documents thoroughly before installing, operating, maintaining, or inspecting the inverter. In this Instruction Manual, safety instructions are classified into two levels, namely WARNING and CAUTION.: Indicates that incorrect handling may cause hazardous situations, which may result in serious ！. • Safety Instructions 3.

Operation WARNING - While power is supplied to the inverter, do not touch any terminal or internal part of the inverter, check signals, or connect or disconnect any wire or connector. Otherwise, you run the risk of electric shock or fire. - Be sure to close the terminal block cover before turning on the inverter power.

• Safety Instructions Precautions Concerning Electromagnetic Compatibility (EMC) The L700 series inverter conforms to the requirements of Electromagnetic Compatibility (EMC) Directive (2004/108/EC). However, when using the inverter in Europe, you must comply with the following specifications and requirements to meet the EMC Directive and other standards in Europe: ！. • They are used to provide both an adjustable voltage and adjustable frequency to the ac motor.

The inverter automatically maintains the required volts-Hz ration allowing the capability through the motor speed range. “Use 60/75 C CU wire only” or equivalent. For models L700 series except for L700-110H and L700-150H. • Safety Instructions 11. Distribution fuse / circuit breaker size marking is included in the manual to indicate that the unit shall be connected with a Listed inverse time circuit breaker, rated 600 V with the current ratings as shown in the table below: Model No.

• Contents Chapter 1 Overview 1.1 Inspection of the Purchased Product 1 - 2 1.1.1 Inspecting the product 1 - 2 1.1.2 Instruction manual (this manual) 1 - 2 1.2 Method of Inquiry and Product Warranty 1 - 3 1.2.1 Method of inquiry. • Chapter 1 Overview This chapter describes the inspection of the purchased product, the product warranty, and the names of parts. Inspection of the Purchased Product 1 - 2 Method of Inquiry and Product Warranty 1 - 3 Exterior Views and Names of Parts 1 - 4. • After unpacking, inspect the product as described below. If you find the product to be abnormal or defective, contact your supplier or local Hitachi Distributor. (1) Check the product for damage (including falling of parts and dents in the inverter body) caused during transportation. • The warranty period under normal installation and handling conditions shall be two (2) years from the date of manufacture (“DATE” on product nameplate), or one (1) year from the date of installation, whichever occurs first.

The warranty shall cover the repair or replacement, at Hitachi’s sole discretion, of ONLY the inverter that was installed. • Chapter 1 Overview 1.3 Exterior Views and Names of Parts The figure below shows an exterior view of the inverter (model L700-185LFF/HFF to L700-300LFF/HFF).

Front cover POWER lamp ALARM lamp Digital operator Spacer cover Terminal block cover Specification label Exterior view of shipped inverter For the wiring of the main circuit and control circuit terminals, open the terminal block cover. • Chapter 2 Installation and Wiring This chapter describes how to install the inverter and the wiring of main circuit and control signal terminals with typical examples of wiring. Installation 2 - 2 Wiring 2 - 6. • Chapter 2 Installation and Wiring 2.1 Installation CAUTION ！ - Install the inverter on a non-flammable surface, e.g., metal.